Wavion WBS-2400 Installation Manual page 2

Note: To better reflect the value of Wavion products we are changing the name of our
product family from Access Points (AP) to Wireless Base Stations (WBS), consequently
the existing WS-410 product name will be changed to Wavion WBS-2400.
The new product name emphasizes the difference in architecture (Multiple Radio system)
and the value to customer, superiority in performance (coverage, capacity, indoor
penetration and immunity to interference) of Wavion WiFi base station over any other
standard outdoor WiFi access point products available in the market.
All references in Wavion's documentation to WS-410 refer also to the WBS-2400, and
vice versa. Both products are exactly the same except for the name change.
Copyright Notice
©2006, 2007, 2008 Wavion, Inc. All rights reserved. Wavion is a registered trademark of
Wavion in the United States and certain other jurisdictions. Specifications are subject to
change without notice.
FCC Notice to Users and Operators
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his own expense. If this equipment
does cause interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to correct the interference by
using one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician.