W W i-Fi LED
The Wi-Fi LED is off when you take the My Passport Wireless drive out of the box.
LED Behavior/Color
Off
Blinking Blue
Solid Blue
Fast-Blinking Blue
Other LED Behavior
LED Behavior
All LEDs fast blinking Blue
All LEDs blinking blue in one long (3 sec) and 3 short
blinks.
Blinking Blue
Blinking Blue
Buttons
Power button
Battery / WPS button
My Passport Wireless Pro
User Manual
Indicates ...
Wi-Fi not active (device is off)
Device is booting up, connecting to wireless, or shutting down.
Wireless network connected or active (all modes)
Wi-Fi Protected Setup (WPS) is initiated and in progress
Indicates...
Device has a problem. Contact WD Support.
Device in recovery mode.
Firmware update in progress.
File I/O in SD card/USB port syncing; Mounting USB
storage; Scanning SD card
Turns the drive on and off and wakes the drive from standby
mode:
•
To turn on from standby, momentarily push until lights
start blinking.
•
To turn off, push for approximately 3 seconds.
Connects to a router using WPS.
•
Press and hold approximately 5 seconds to start WPS.
•
When the drive is off, press to show battery status briefly.
•
Press momentarily for other devices to connect to the
My Passport Wireless network in Home mode
•
With SD card inserted in the slot, press momentarily to
start SD card transfer.
Understanding the LEDs and Buttons
6