Safety - Marine PC MPC-AWM3V User Manual

SAFETY

General Safety Instructions
• Before operating the MPC-AWM3V Monitor, read this User Manual thoroughly
• Retain this User Manual for future use
• For expeditious installation, follow these User Manual instructions in sequence
• Adhere to all Caution and Warnings on system and as stated in this User Manual
• All User Manual instructions for installation and operation must be followed
precisely
• Adjust only those controls covered by the User Manual's operating instructions; improper
adjustment of other controls voids the unit's warranty and may result
in unit damage, and
• Adhere to local installation codes.
Warning! Shock Hazards
This icon is intended to tell you of a potential risk of electrical shock.
warning!
Caution! Instructional
This icon is intended to tell you of important operating and/or
caution!
maintenance instructions.
General Unit Safety
• Always disconnect the unit from the power source before cleaning
• Do not operate the unit with a damaged cord
• Do not operate if the unit has been dropped or damaged. The unit needs inspection
by qualified Marine PC Service Personnel
• Position the power cord so it will not be in contact with hot surfaces
• Do not allow anything to rest on the power cord, and
• Do not place the power cord where there will be foot traffic.
General Safety Precautions
warning!
• Power cord must be connected to a properly wired and grounded power source
• Any equipment to which the unit will be attached must also be connected to properly wired and
grounded power sources
• Do not connect or disconnect the unit during an electrical storm
• Do not remove the unit covers – there are no user serviceable parts in the unit
• Do not disassemble or modify the unit to avoid the possibility of electrical shock,
damage to electrical components or scratching the Display surface, and
• Disassembly of the unit voids the warranty.
6
UM-MPC-AWM3V(A) 10/2011