Panel Mount - Marine PC MPC-AWM3V User Manual

There are three mounting holes in the back of the Monitor for the ball mounting plate.
Take care not to strip the screw holes or over tighten. (Figure 4)
• Note the location of the three mounting holes on a ball mounting plate (Figure 4)
• With three (3) M4 x 10 counter-sunk stainless screws attach this mounting plate to the back
of the MPC-AWM3V.
Take care not to strip the
screw holes or over tighten
as the enclosure is aluminum.
caution!
• Mount the second ball mounting plate where the Monitor will be installed
• Insert each ball into the RAM arm
• Lightly tighten the arm around the balls using the T-knob on the arm (Figure 2, 4)
• Adjust the Monitor to the viewing preference, and
• Tighten the T-knob to hold the Monitor in position.
It is recommended the remaining ball be mounted on a flat surface. Because of the
various surface substrates the Monitor will be mounted on, the installer will provide
the screws to mount the other ball.

Panel Mount

The Panel Mount installation should be specified at the time of order; the ball-and-
socket mount system will not be included in the shipping box.
The mounting hardware packet is included with the unit accessories in the shipping
box. This packet includes four (4) threaded screws (approximately 7.6 cm [3"] long),
four (4) Nylock nuts and four (4) flat washers. For installation, there are four tapped
mounting holes on the four corners of the unit's rear panel.
It is recommended the installer refer to the mount drawings on the User CD or on
Marine PC's web site, (www.marinepc.com/support), for the exact measurements of the unit's
rear panel pod. These drawings should be helpful when the installer cuts the
required opening for the Panel Mount installation.
Take care not to strip the
screw holes or over tighten
caution!
as the enclosure is aluminum.
Flush Mount with Optional Bezel
With the optional Flush Mount Bezel, the MPC-AWM3V LCD Display may be mounted flush with
the mounting surface; the ball-and-socket mount system will not be included in the shipping
box. The installer will need to supply screws for this type of installation.
The mount diagram of the Flush Mount Bezel is on the User CD and on Marine PC's web site,
(www.marinepc/support). When the placement site has been decided, it is recommended the
installer use these measurements when cutting the opening for
the Monitor's installation.
Note the locations of the milled holes in the Flush Mount Bezel. Drill corresponding holes into
the substrate where the Monitor will be mounted.
UM-MPC-AWM3V(A) 10/2011
11