Scanning
Automatic Lamp Illumination on Scan Stop
The FT-65R/E will automatically illuminate the LCD/Keypad Lamp whenever the scanner
stops on a signal; this allows you to see the frequency of the incoming signal better at
night. Note that this will, of course, increase the battery consumption, so be sure to switch
it off during the day (the default setting is "ON").
1. Press and hold the F key to enter the Set Mode.
2. Press the [▲] or [▼] key to select Set Mode Item
"27 SCN. LAMP".
3. Press the F key to enable adjustment of this item.
4. Press the [▲] or [▼] key to select "OFF".
5. Press the PTT switch to save the new setting and return to normal operation.
FT-65R/FT-65E Advance Manual
22