Tank Connection, Filtration, Mounting Orientation - Linde HPR-2 Manual

Operational parameters. Tank connection, filtration, mounting orientation
Tank connection
The leakage and decompression oil generated during pump operation is drained from the rotating group into the pump housing.
Excessive housing pressure must be avoided through suitably dimensioned piping between the housing and the tank.
Filtration
High purity oil can extend the service time of the hydraulic system significantly. In order to guarantee long-term proper function
and high efficiency of the hydraulic pumps the purity of the pressure fluid must comply with the following criteria.
>> For reliable proper function
and long service life
>> Minimum requirements
>> Commissioning
>> Filling and operation
of hydraulic systems
>> International standard
Mounting orientation
The preferred mounting orientation is generally horizontal. Pump configurations for vertical mounting with the shaft pointing
upwards have an additional drain port "R" at the mounting flange. These units are available with certain combinations of features
and have to be requested separately.
For further information concerning the installation of the unit please refer to the operating instructions manual.
18/16/13 in accordance with ISO 4406 or better
20/18/15 in accordance with ISO 4406
The minimum purity requirement for the hydraulic oil is based on the most sensitive system
component. For commissioning we recommend a filtration in order to achieve the required
purity.
The required purity of the hydraulic oil must be ensured during filling or topping up.
When drums, canisters or large-capacity tanks are used the oil generally has to be
filtered. We recommend the implementation of suitable measures (e.g. filters) to
ensure that the required minimum purity of the oil is also achieved during operation.
code number according to ISO 4406
18/16/13 corresponds to
20/18/15
purity class according to SAE AS 4059
8A/7B/7C
9A/8B/8C
7