Pumps According To Iso 3019-2 And Sae J617A - Linde HPR-2 Manual

Torque transmission. Pumps according to ISO 3019-2 and SAE J617a
The previously given information and dimensions refer to pumps according to ISO 3019-1 (SAE J 744). In addition to that, certain
configurations are available according to ISO 3019-2. These units offer an additional drain port "R" at the mounting flange for
upright installation and a keyed drive shaft.
Rated size
Mounting flange
Mounting
Screw hole diameter
Screw contact surface
Clamping length
Centring
Mounting hole distance
Shaft diameter
Key acc. to DIN 6885
Excess length
Height
Port R
>> Further dimensions and position of the other ports, see <<Dimensions. Single pumps HPR-02 for TL2, LEP, ETP>>
Detailed shaft view
K
D
R(B)
Linde HPR pumps can be delivered matching a flange according to SAE J617a. The pumps are therefore equipped with an adaptor.
Depending on the rated size, the base unit is a standard HPR-02 or a plug-in type HPR-02. The plug-in-flange is shown in section
<<Dimensions. Double pumps and plug-in pumps>>.
According to SAE J617a
SAE 3
SAE 3
SAE 4
SAE 5
M1
M2
M3
D
K
W1
W2
W3
W4
Size
Position bottom, as port "T"
R(L)
R(H)
R(B)
View on R
Rated size Base unit
105, 105D, 135 plug-in
165, 165D SAE D 2-hole with 4 additional bolt holes
105, 105D, 135 plug-in
55, 75, 105 SAE C 2-hole
105
125A2SW
2-hole
17.5
40
30
125
180
40
12x8x80
92
23
M14x1.5 13 deep
15.5
approx. 80
40
Mounting flange
R(L)
280
224B4SW
4-hole
22
40
30
224
198
60
18x11x100
115
53
side, as port "U"
15
50
152
W2
W3
15