Cable Installation Guidelines - Extreme Networks Extreme Wireless Site Preparation And Installation Manual

Figure 23: WS-AO-DT05120 and Related Antenna Models
Table 14: Antenna Cable and Connector Information
Antenna Model
WS-AO-DT05120
WS-AO-DT05120-1
WS-AO-DT05120N
WS-AI-DT05120
Wave 2 Antennas
For specific information on antennas that support the AP3805e and information on each AP39XX series
antenna, refer to Antenna Specifications

Cable Installation Guidelines

The cable configuration that you use to connect an AP to an antenna varies. Use the following sections
as guidelines for cabling your AP to an antenna.
Do not install the cable in tight positions, as bending or applying excessive force to the connectors may
damage the antenna cable. Always allow the cable to bend naturally around corners.
The low-loss antenna cable must be secured along its complete length. Do not allow any part of the
cable to hang free. This is particularly important for cable parts that are installed outdoors. The antenna
cables and cable connectors are not designed to withstand excessive force:
•
Do not use connectors as cable grips to pull cable through raceways or conduits.
•
Do not use cable connectors to support the weight of the cable during or after installation.
•
Do not use tools to tighten connectors (finger-tighten only).
ExtremeWireless™ External Antenna with Wave 2
Cable Type Cable Length
RG316 32 inches
RG316 32 inches
RG316 32 inches
RG316 32 inches
on page 41.
Antenna Installation
Connector Type
Reverse Polarity, Type N Jack
Reverse Polarity, Type N Plug
Standard Polarity, Type N Plug
Reverse Polarity SMA Plug
39