Extreme Networks Extreme Wireless Site Preparation And Installation Manual page 28

Table 11: Mount Kit Contents
Item Quantity
1 4
2 1
3 1
4 1
5 1
6 4
7 4
8 1
9 1
10 1
11 1
12 4
13 4
14 4
Tools required for attaching mount to antenna and securing to pole:
•
7/16 inch wrench
•
1/2 inch wrench
To install the antenna:
1 Remove the antenna and mount kit from the packaging, and remove the mount kit contents from its
packaging. Confirm that the mount kit includes the contents listed in
2 Install 1/4-20 x 2" screw (item 9) into the bracket (item 8) with one hole on each flange. Secure with
lock nut (item 10). Tighten only until the nut contacts the bracket. Do not over tighten.
Figure 9: Install Screw in Bracket
ExtremeWireless™ External Antenna with Wave 2
Description
Nut, 5/16-18,1/2" Hex. 17/64" Thick, Steel Grade 2,NlZN Trivalent
Bolt, Carriage, 5/16-18 x 3/4
Bracket, Mount. Antenna
Bolt, 5/16-18 x 2 1/2", Hex Head, Steel, Nl ZN Trivalent
Tube, Aluminum, 0.37" ID x 0.50" OD x 1.415"
Washer, Flat, 5/16, 5/8" OD x 11/32" ID x 0.065", Steel, Zinc
Washer, Split Lock, 5/16, Steel Grade 2, Nl ZN Trivalent
Bracket, Mount, Antenna
Screw, Hex Head, 1/4-20 x 2.0,18-8 SS
Nut, Hex, Nylock, 1/4-20 UNC
V-Bolt, 5/16-18 UNC-2A, Med. Carbon Steel, Nl ZN Trivalent
Washer, 1/4 Flat, Steel Grade 2, Nl ZN Trivalent
Nut, Hex 1/4-20, Steel Grade 2, Nl ZN Trivalent
Washer, 1/4, Split Lock, Steel Grade 2, Nl ZN Trivalent
Antenna Installation
Table 11.
28