Extreme Networks Extreme Wireless Site Preparation And Installation Manual page 38

Figure 22: WS-AI-DX02360 Mounting Post and Mounting Nut
To install the antenna in a suspended ceiling:
1 Mark the desired mounting location on the suspended ceiling tile and cut a 40 mm (1.57 in) hole in
the tile.
2 Feed the six antenna cables through the hole and press the antenna to the ceiling tile.
3 Secure the antenna with the mounting nut, as shown in
4 Connect the cables to an access point by means of coax pigtails.
The cables are marked by colored heat-shrink wrap and labels, indicating the three cables for 2.4 GHz
connections and the three cables for 5 GHz connections.
A rubber locking gasket is also supplied with the antenna. Use this gasket with the mounting nut only
when mounting the antenna to a hard surface.
If access to the back of the mounting surface is not available, use the two mounting holes shown in
previous figure to attach the antenna with #8 screws and expanding anchors (not supplied).
Mounting Antenna Model WS-AO-DT05120 and Related Antenna Models
The WS-AO-DT05120 and related models is a 2.4 and 5 GHz dual-band sector antenna that can be
mounted in an outdoor location. The WS-AI-DT05120 antenna model is intended for indoor locations.
Each antenna has three connectors and is especially designed for MIMO APs.
and cable information. These antennas can also be mounted on a wall or on a pole.
ExtremeWireless™ External Antenna with Wave 2
Antenna Installation
the previous figure.
Table 14
the
shows connector
38