Setup Using Epsonnet Config (Web Version) - Epson TM-T88VI-iHUB Reference Manual

Setup using EpsonNet Config (Web version)

Follow the steps below to start up EpsonNet Config (Web version), and check or change the settings.
 When setting up using the EpsonNet Config (Web version), you need to set the network settings
for the device to the same network segment as the printer you want to connect to.
 The initial setting uses an IP address for the printer provided by a DHCP server. Since you cannot
complete setup if there are conflicting IP addresses on the network, make sure that there are no
other devices on the network that conflict with the IP address provided by the DHCP server. If a
DHCP server is not available, a fixed IP address (192.168.192.168) is set approximately one minute
after turning on the printer. Also, if the Ethernet cable is not connected, connect the Ethernet cable
and then run this process.
 When DHCP is enabled, the provided IP address is printed automatically. However, if the Ethernet
cable is not connected, and the Wireless LAN unit is not installed, printing is not performed.
1
Connect the setting computer and the printer to the same network.
2
Perform network settings on the computer so that it is in the same segment as the
printer's IP address.
Subnet mask: Same subnet mask as the printer
IP address: Same segment (same network address) as the printer, different host address
Check the values set in the printer on the status sheet.
E.g.)
Subnet mask
IP address
3
Start up your Web browser and input the printer's IP address into the address field.
E.g.) http://192.168.192.168/webconfig
4
Input your user name and password on the authentication window.
Input "epson" for both the user name and password. You can change the password in the [Optional]
setting menu, under [Password].
5
Change the settings based on the network setting information you received from the
network administrator.
Select an item from [Configuration] and change the setting.
6
After changing the necessary parameters, click the [Send] button.
The changes are sent to the printer.
Printer
255.255.255.0
192.168.192.168
Under initial settings, when you access EpsonNet Config (Web version) from your browser, an
authentication warning message may be displayed.
Chapter 3 Advanced Usage
Setting computer
255.255.255.0
192.168.192.2
3
67