Table of Contents
Advertisement
Printing and Cutting Positions
Manual-cutter position
Autocutter blade position
Center of the print dotline
The values above may vary slightly as a result of paper slack or variations in the paper. Take
When removing cut paper, the remaining roll paper is pulled at the uncut section and the
When leaving paper loaded for an extended period of time, make sure you feed about 30 mm
128
this into account when setting the cutting position of the autocutter.
pitch of the next print may be reduced. When printing after cutting paper for prints with no
pitch reduction, feed the paper about 1 mm {16/406 inches} before printing.
of paper. This can prevent paper from wrinkling and causing prints to be too light.
Approx. 15
Printable area
[units: mm (All the numeric values are typical.)]
Last line of
a previous receipt
Approx. 29
Paper feed direction
Advertisement
Table of Contents
