Installation - Scott SRX190 User Manual And Installation Instructions

Installation

Notes:
- Choose the mounting location where the unit will not interfere with the normal driving function of the driver.
- Before finally installing the unit, connect the wiring and make sure that the unit works properly.
- Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
- Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an
emergency stop.
- If installation ang e exceeds 30°from horizontal, the unit l may not perform properly.
- Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the
heater, or where it would be subject to dust, dirt or excessive vibration.
Remove the CD mechanism transit screw before installation
Before install the unit, must remove the two screws with label "REMOVE SCREW".
Installation Opening
This unit can be installed in any dashboard having an opening as shown below (DIN standard):
53 mm
182 mm
GB-4