Installation - Scott MCX32 User Manual And Installation Instructions

1. INSTALLATION

Notes:
- Before the installation of the unit, make the electrical connections and ensure everything is connected properly and that the unit works
correctly.
- Consult your dealer if installation requires the drilling of holes or other modifi cations of the vehicle.
- Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency
stop.
- If installation angle exceeds 30° from horizontal, the unit may not perform properly.
Remove the CD mechanism transit screws before installation
Before installing the unit, remove the two screws which are labelled "REMOVE SCREW".
Installation opening on the dashboard
This unit can be installed in any dashboard opening with the following dimensions (DIN standard):
Installing the unit
After making all the connections, ensure that the unit is working properly, then follow these steps to install the unit.
1. Make sure the ignition is turned off. Disconnect the cable from the vehicle battery negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Press the REL ( ) button to remove the control panel (for details, refer to 'USING THE DETACHABLE FRONT PANEL').
GB-3