Error Messages - Ravas iForks User Manual

6.7

Error messages

ERROR MESSAGES
Display Meaning
Err01 Load cell signal is unstable
Err02 Overload on full scale
Err03 Gross negative. This action is not allowed
Err04 Out of zero range
Err05 Sampling accuracy too low
Err06 Input signal too high
Err08 Calibration out of range (negative)
Err09 Calibration out of range (signal too low)
Err10 Calibration count 2nd(3rd) point lower than count
1st(2nd) point
Err14 Setpoint value 2 < setpoint value 1. This is not allowed
Err97 Legal for trade version: not allowed action
Err98 Calibration point must be higher than previous one
Err99 Action only allowed in start-up units
ErrF1 Problem with fork 1 (no communication)
ErrF2 Problem with fork 2 (no communication)
---- Loadcell signal negative
L - _ Forks are out of level (only legal-for-trade version)
ErrCS Problem with correction sensor
Battery of indicator is empty
+F1
Battery of fork 1 is empty
+F2
Battery of fork 2 is empty
DISPLAY MESSAGES
Display Meaning
BltF1 Successful Bluetooth link with fork 1
BltF2 Successful Bluetooth link with fork 2
Out of error mode
Automatic
Automatic after removing weight
Automatic
Press any key
Press any key
Automatic after correcting input
Automatic
Automatic
Automatic
Automatic
When action is intended, install jumper JP1
( attention: after this action a complete
new calibration and stamping of the
system is necessary )
Automatic
Automatic
Restart indicator. Restart forks & indicator
Restart indicator. Restart forks & indicator
Lift up the forks from the ground
Put the forks into horizontal position
Contact the RAVAS Service department
Replace the 4 AA batteries
Replace the D-cells in both battery packs or
charge both battery packs
Replace the D-cells in both battery packs or
charge both battery packs
No error
No error
USER MANUAL –
iForks 21