Changing - Mercury TDI 4.2L Manual

Section 4 - Maintenance
3. Fill the gear lube monitor with the specified gear lube so that the gear lube level is in the operating range. Do not overfill.
c
a
Tube Ref No.
High Performance Gear Lube
87
4. Ensure that the rubber gasket is inside the gear lube monitor cap and install the cap. Do not overtighten.
a
NOTE: When filling the entire sterndrive, refer to Changing .

Changing

1. Remove the gear lube monitor from the bracket.
a
2. Empty the contents of the gear lube monitor into a suitable container.
3. Install the gear lube monitor in the bracket.
4.
Bravo One X Models:
a. Remove the propeller.
b. Lower the sterndrive to the full down (in) position.
c. Remove the gear lube fill and drain plug and sealing washer.
Page 40
b
Description
a - Gear lube monitor cap
19962
b
Gear lube monitor
a - Gear lube level at the "ADD" mark
b - Gear lube level at the "OPERATING RANGE" mark
c - Gear lube monitor cap
19947
Where Used
Gear lube monitor
a - Gear lube monitor bracket
b - Gear lube monitor and cap
c - Retaining strap
c
5500
92-858064K01
90-8M0114081 DECEMBER 2015
eng
Part No.