Mitsubishi Electric AJ65SBT2B-64DA User Manual page 25

No. Name
Use the switches in STATION NO. "10", "20" and "40" to set the tens of the
station number.
Use the switches in STATION NO. "1", "2", "4" and "8" to set the units of the
station number.
The switches are all factory-set to OFF.
Always set the station number within the range 1 to 64.
Cannot set the same station number to two or more stations.
Setting any other number than 1 to 64 will result in an error, flickering the "L
ERR." LED.
Station
number
5
setting
switches
(Example) To set the station number to "32", set the switches as indicated
below.
Use
Set all switches to off.
6
prohibited
Terminal Used to connect the module power supply, transmission and analog I/O
7
block signals.
DIN rail
Used to mount the module to the DIN rail.
8
hook
L TER. (Line Turned ON to validate the terminating resistor stored in the AJ65SBT2B-
Termination) 64DA.
9
switch Used when the AJ65SBT2B-64DA is used on the network edge.
* The transmission speed is automatically set depending on the setting of the
master module.
Table 3.1 Part names
Tens
Station
number
40 20
1 OFF OFF
2 OFF OFF
3 OFF OFF
4 OFF OFF
10 OFF OFF
11 OFF OFF
64 ON ON
Tens
Station
number
40 20
32 OFF ON
Description
10 8
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF OFF
10 8
ON OFF
8
Units
4 2 1
OFF OFF ON
OFF ON OFF
OFF ON ON
ON OFF OFF
OFF OFF OFF
OFF OFF ON
ON OFF OFF
Units
4 2 1
OFF ON OFF