Table of Contents
Advertisement
Related links
Removing a hard drive
Removing the 2.5 inch drive cage
Removing the 3.5 inch drive cage
Installing the control panel
Installing the control panel
Prerequisites
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
NOTE:
Additional tape maybe required to secure the cables.
Follow the safety guidelines listed in
Steps
1
Route the control panel cable through the cable retention clips.
2
Install the control panel assembly and secure it in place with screws.
Figure 70. Installing the left control panel
Safety
instructions.
Dell PowerEdge C6400 Installation and Service Manual
Installing and removing enclosure components
83
Hide quick links:
Advertisement
Table of Contents
