Table of Contents
Advertisement
6. Troubleshooting & Maintenance
l No image on display:
l Ensure that the display device has been set to the correct input.
l Ensure that the HDMI cables used for both the source/transmitter and the
receiver/display are properly connected and are working. Test the HDMI cables
directly from a source to display and ensure their operation.
l Ensure that the Cat5e/Cat6 cable has not been damaged and that it has been
terminated correctly with T568B on both ends. A temporary length of
Cat5e/Cat6 can be used for testing to ensure that the devices are all compatible
and working properly.
l Ensure proper grounding of the power supply.
l Ensure shielded cable with shielded connectors is being used.
l Color loss or poor picture quality:
l Ensure that the HDMI cables used for both the source and transmitter and the
receiver and display are properly connected and are of good quality. Test the
HDMI cables directly from a source to display and ensure their picture quality.
l Ensure proper grounding of the power supply.
l If the static becomes stronger or picture quality becomes worse when
connecting the video connectors, this may be due to improper grounding.
l Check the grounding and make sure all the components are properly grounded to
a common ground. Improper grounding may cause damage to the receiver.
l Unsteady image
l Ensure that the Cat5e/Cat6 cable has not been damaged and that it has been
terminated correctly with T568B on both ends. A temporary length of
Cat5e/Cat6 can be used for testing to ensure that the devices are all compatible
and working properly.
l Adjust the EQ switch to compensate for cable distance.
If your problem persists after following the above troubleshooting steps, seek
further help from an authorized reseller or our TechLogix technical support.
TL-TP50-HDIR User Manual
9
www.tlnetworx.com
Advertisement
Table of Contents
