Page 1
User Manual TL-TP70-HDC 70m Twisted Pair Extender Set for HDMI, RS232 & All Rights Reserved Version: TL-TP70-HDC _180619...
Page 2
TL-TP70-HDC User Manual Preface Read this user manual carefully before using this product. Pictures shown in this manual are for reference only; the actual product may vary. This manual is only for operation instruction only and not for any maintenance or repair.
Page 3
TL-TP70-HDC User Manual SAFETY PRECAUTIONS To insure proper operation, please read all instructions carefully before using the device. Save this manual for further reference. ⚫ Unpack the equipment carefully and save the original box and packing material for possible future shipment ⚫...
1.1 Introduction to TL-TP70-HDC The TL-TP70-HDC is an ultra-thin extender set consisting of a transmitter (TL-TP70- HDC-T) and a receiver (TL-TP70-HDC-R). The set transmits an HDMI signal to the receiver up to 70m distance via a Cat5e/Cat6A cable. Featuring bi-directional IR and RS232, you can control your display or source using included accessories.
TL-TP70-HDC User Manual 2. Panel Description 2.1 Transmitter LINK HDCP TP OUT TP OUT Name Description TP link status indicator OFF: no link ➢ LINK ① GREEN: link successful ➢ Blinking GREEN: link abnormal ➢ HDCP compliant indicator OFF: no HDMI traffic (no picture) ➢...
TL-TP70-HDC User Manual HDMI IN Connect to an HDMI source ⑦ Connect to the TP IN socket on the receiver via a twisted pair TP OUT ⑧ cable; supports bi-directional PoC Connect to the power supply (Note: power is only required on the DC 24V ⑨...
Page 8
TL-TP70-HDC User Manual OFF: No power Power ③ RED: DC power present RS232 RS232 control connector ④ Connects to a 5V IR receiver (with carrier); signals tranmitted to the IR IN ⑤ remote transmitter Connects to a 5V IR emitter (with carrier); signals tranmitted from IR OUT ⑥...
TL-TP70-HDC User Manual 3. System Connection 3.1 Usage Precautions 1) System should be installed in a clean environment that has a proper temperature and humidity. 2) All of the power switches, plugs, sockets and power cords should be installed properly.
TL-TP70-HDC User Manual receiver. Connect the IR receiver to the IR IN port on either the transmitter or receiver. Step5. If RS232 control is required, connect the RS232 port of the devices to be controlled to the receiver or the transmitter.
⚫ Check the grounding and make sure all the components are properly grounded to a common ground. Improper grounding may cause damage to the receiver. If your problem persists after following the above troubleshooting steps, please contact your authorized reseller or TechLogix technical support. www.tlnetworx.com...
⚫ No certificate or invoice as the proof of warranty ⚫ Damage caused by force majeure ⚫ Non-authorized service 3) Technical Support: When contacting TechLogix support, please have the following information available: ⚫ Product part number ⚫ Installation and sale date ⚫...