Digitrax Zephyr xtra Manual page 47

3. Use the numeric keypad to enter the loco address you want to run, in this
case locomotive
on JUMP 1. The display will be steady and you will be able to control the
speed and direction of the loco you selected using the DC power pack
attached to JUMP 1.
4. When you have JUMP 1 on the DCS51's display (JUMP Indicator Dot is
steady), you can use the numeric keys to make changes to the function con-
trols on the JUMP 1 loco (turn on/off lights etc.). The smooth DC power
pack being used as the JUMP 1 throttle will continue to control speed and
direction of the loco address selected on JUMP 1. The DCS51's Throttle
Knob and Direction Control Lever will continue to control the speed and
direction of the loco selected on the Local Throttle (loco 3856 from the
previous section).
Note: You must have functions/lights installed and connected to the func-
tion leads of the decoder in order for the function keys to work. Many DCC
ready locomotives have the headlight installed and the headlight can be
turned on and off with the
and connected in order to use the Whistle and Bell functions. A special cou-
pler is required in order to use the Coupler function.
©2012 Digitrax, Inc.
, on JUMP 1 and press the
67
laMp/0
www.digitrax.com
lOCO
key. A sound board must be installed
key again to select it
46