Digitrax Zephyr xtra Manual page 46

2. Press the
JuMp
3. Press the
JuMp
4. Press the
JuMp
To run a locomotive address on Jump 1:
1. Press the
JuMp
JUMP Indicator Dot on steady and a screen like this if there is nothing
selected on JUMP 1.
Or, you'll see a screen similar to this if there is a locomotive address, in this
case 481, selected on JUMP 1
2. To select a loco on JUMP 1 or to change the loco that is already there,
press the
lOCO
loco selection is pending. The display will now show the last loco that was
selected on this throttle. It will look something like this:
©2012 Digitrax, Inc.
key to view Jump 1:
key again to view Jump 2:
key again to return to the Local Throttle:
key until you have JUMP 1 in the display, you'll see the
key. The screen will begin flashing to let you know that the
www.digitrax.com 45