Uniden BC350C Manual page 14

[WX] KEY
[CB] KEY
[SEARCH] KEY
[L/O] KEY
[BAND] KEY
Seven NOAA frequencies are
programmed into the Weather (WX)
bank. Press [WX] to find your local
weather channel.
XXCB channels are programmed into
the CB bank. Press [CB] to start
scanning CB channels.
Press [SEARCH] to start searching
active frequencies within the band
previously selected with the [BAND]
key. Normally, the search continues
from the frequency where it left off in
the previous search. In Search Mode,
(after pressing [SEARCH]), the
[BAND] key becomes active.
Use [BAND] to select the band you
wish to search. When selecting a
band to search, release the key and
the scanner will automatically start
searching upward from the lowest
frequency of its band. (The symbol
appears next to "SRCH" on the
display.) To search from a higher
frequency to a lower frequency, press
[DOWN]. (The symbol is now
displayed next to "SRCH".
Press [L/O] to "lock out" or prevent
scanning of the displayed frequency.
[L/O] is active only during opened
squelch or in the Hold Mode.
Locked out channels can be
displayed on the screen by using the
[UP] or [DOWN] key to manually
scan through the selected bank in
Hold Mode only. "L/O" appears on
the display to indicate that the
channel is locked out. Note: Locking
out a channel will not erase the
programmed frequency.
This key is active in Search Mode
only (when "SRCH" is displayed on
the screen). When you press
[BAND], the upper and lower limits of
the band you are searching are
displayed for 3 seconds. Then the
12