Wi-Fi Protected Setup (Wps) - TRENDnet tew-737hre User Manual

Beacon Interval – A beacon is a management frame used in wireless networks that transmitted periodically to announce the
presence and provide information about the router's wireless network. The interval is the amount time between each beacon
transmission.
Default Value:100 milliseconds (range: 25-1000)
RTS Threshold – The Request To Send (RTS) function is part of the networking protocol. A wireless device that needs to send data
will send a RTS before sending the data in question. The destination wireless device will send a response called Clear to Send (CTS).
The RTS Threshold defines the smallest data packet size allowed to initiate the RTS/CTS function.
Default Value: 2346 (range: 256-2346)
DTIM Interval – A Delivery Traffic Indication Message (DTIM) is an informational message that is sent as part of a beacon by an
access point (your wireless router) to a wireless client (wireless device or connecting station) in sleep mode to provide an alert that
data is awaiting delivery. The DTIM Interval (also called Data Beacon Rate) is the amount of time between DTIM transmissions
included in part of a beacon.
Default Value: 1 (range: 1-255)

Wi-Fi Protected Setup (WPS)

If your wireless device has WPS PIN (typically an 8-digit code printed on the wireless device product label or located in the wireless
device wireless software utility), you can use this method.
WPS: Enable or Disable the WPS (Wi-Fi Protected Setup) function
Status: Display the state (Un-configured State/Configured State) information of WPS.
Self-PIN Number: Display the default PIN number of WLAN Router.
Client PIN Number: Type Client PIN number the client uses to negotiate with WLAN Router via WPS protocol. It is only used when
users want their station to join Router's network.
Push Button Configuration: Clicking the Start PBC button will invoke the Push Button Configuration (PBC) method of WPS. It is only
used when WLAN Router acts as a Registrar.
8