Table of Contents
Advertisement
TRENDnet User's Guide
Basic Setup
Wi-Fi Protected Setup (WPS) Push Button Configuration (PBC)
Setup
WPS is a feature that makes it easy to setup the TEW-736RE to your wireless network. If
your wireless router or access point does not have a WPS button, set up the TEW-736RE
using the Setup Wizard Configuration method outlined in the following section.
Note:
• Make sure your wireless router or access point has a WPS button.
• Do not connect the TEW-736RE until instructed to do so.
• The initial installation can be performed next to your wireless router or access point.
1. Connect the Power Adapter to the TEW-736RE and then to a power outlet (EU
Versions will have a power button on the back. Push the power button to the "On"
position).
2. Verify that the power is on.
3. Press and hold the WPS button on your wireless router or access point for 5
seconds. If you router or access point has a WPS LED indicator, it should start
flashing.
4. Press and hold the WPS button on the TEW-736REfor 5 seconds.
© Copyright 2011 TRENDnet. All Rights Reserved.
5. Once connection has been successfully established the WPS LED on the TEW-736RE
will automatically turn off.
6. Place the TEW-736RE in your desired location.
7. Plug in the power adapter into the TEW-736RE and verify that the panel lights are
on.
8. Verify the TEW-736RE is now connected to your network. Connect your computer
to the Network port on the back of the TEW-736RE. Confirm that the wireless
function of your computer is turned off. Open an Web browser and confirm that
you can access the Internet.
Note:
•
The TEW-736RE must be placed in a location where it can establish a wireless
connection to your wireless network. The most ideal locations are areas where
wireless adapters can maintain 2-3 bars with your existing router or a 20-30%
connection rating.
When conducting a wireless scan you may see the router's wireless network name
•
listed twice. This is normal because the TEW-736RE broadcasts the same network
name as your router or access point.
Setup Wizard Configuration
The setup wizard provides easy step by step instructions on how to configure the TEW-
736RE to your wireless network. Follow the steps provided below to continue.
Note:
• Do not connect/install the TEW-736RE to your network until instructed to do so.
• Make sure your network adapter settings are set to obtain an IP address
automatically.
1. Using a network cable, connect your computer to the TEW-736RE's LAN ports.
TEW-736RE
7
Hide quick links:
Advertisement
Table of Contents
