Unpacking And Setup; Unpacking; Setup - TRENDnet tew-737hre User Manual

UNPACKING AND SETUP

This chapter provides unpacking and setup information for the N300 High Power
Easy-N-Range Extender.

Unpacking

Open the box of the
contain the following items:
One N300 High Power Easy-N-Range Extender

One CD contain User's Guide

If any item is found missing or damaged, please contact your local reseller for
replacement.

Setup

The setup of the
following methods:
The easiest and most secure way to connect your Wireless Range Extender to your the
router or access point is WPS (Wi-Fi Protected Setup).
Please refer to your user manual for information on your router or access point make sure
you understand how to enable WPS.
Once you know, follow the steps below:
Step 1 - Plug the Wireless Range Extender into a wall outlet and verify if the power
LED has turned from red to a blinking amber.
Step 2 - Press the WPS button on your AP/Router.
Note: Usually the WPS LED will blink once it is pressed. Check your
router's manual for more information.
Step 3 - Press and hold the WPS button until the light starts blinking
green and then release. Please allow up to two minutes for
the WPS process to finish. Once the connection is successful
the LED will be solid green.
Step 4 - Your AP/Router and Wireless Range Extender will be connected when the LED
light turns solid green.
Note: If connection fails, try moving your
router/access point and repeat steps 2 and 3.
Wireless Range Extender
Wireless Range Extender
and carefully unpack it. The box should
can be performed properly using the
Wireless Range Extender
2
closer to your wireless