The Starter Kill And The Anti-Grind Feature; Extended Run Time; Options; Passive Or Active Arming Of The Starter Kill - Autostart AS-1757v User Manual

•
Press and release the
the
START/STOP
To verify whether the system is in Cold Weather Mode:
•
Press the brake pedal:
•
If the vehicle is in cold weather mode, the parking lights will stay on while the pedal is
pressed.

The Starter Kill and the Anti-grind Feature

With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the Starter Kill is armed. If your Remote Car Starter was installed with the Starter Kill
option, one will not be able to start your vehicle with the key unless the system has been unlocked
and disarmed first, or put into Valet Mode.
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the

Extended Run Time

With the vehicle running under a remote start, pressing and holding the
than 3 seconds will reset the run time counter to zero and restart the run time cycle from the
beginning.
The parking lights will flash 3 times to confirm the extended run time.
To stop the vehicle, at any moment, simply press the
be carried out once per remote start.
Example: if your Module is programmed for a run time of 3 minutes and your vehicle has been
running for 2 minutes already, pressing the
Engine will run for another cycle (in this case, 3 minutes).
Advanced Features: Installation-programmable Options
The Remote Car Starter was designed with flexibility and OEM integration in mind. With its
programmable options, this unit can single-handedly control nearly any electrical system in your
vehicle.
Caution: The programming of your system should be left to a professional. Changing any
one of the settings may affect the operation of your Remote Car Starter. Please note that the
following programmable options may require additional parts and labour.

Passive or Active Arming of the Starter Kill

See section "Arming the Starting Kill" earlier in this guide.

OEM-Style Alarm

The OEM-style alarm (if configured by your installer) monitors the doors, hood and ignition switch
of your vehicle. It will sound the horn if a door or the hood is opened, or if the key is turned in the
ignition.
• To arm the OEM-style alarm, press the
- The OEM-style alarm will ONLY arm if the
- The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now
armed.
• To disarm the OEM-style alarm, press the
- To stop the horn from sounding if the OEM-style alarm is triggered, press the
button, or put the system in and out of Valet Mode (ignition valet, remote valet or
UNLOCK
using the valet switch – for more information, see the "Valet Mode" section earlier in
this Guide).
User guide
button. While the LED on the transmitter is flashing, press
PANIC
button until the parking lights flash once.
position.
CRANK
START/STOP
LOCK
button. This procedure can only
START/STOP
button will reset the counter to zero and the
button on the transmitter.
button on the transmitter is pressed.
LOCK
button on the transmitter.
UNLOCK
button for more
START/STOP
LOCK
or
P. 9