Select / Set Button - Siemens SCALANCE XC-200 Operating Instructions Manual

Description of the device

3.3 SELECT / SET button

3.3 SELECT / SET button
Position
The "SELECT/SET" button is located on the front of the device.
Figure 3-1
Setting the display mode
To set the required display mode, press the "SELECT/SET" button.
For more detailed information on the display modes, refer to the section "LEDs "DM1" and
"DM2" (Page 30)".
Resetting the device to factory defaults
NOTICE
Previous settings
If you reset, all the settings you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in the configured network.
26
Position of the button "SELECT/SET", for example on the SCALANCE XC208
Operating Instructions, 07/2016, C79000-G8976-C442-01
SCALANCE XC-200