Troubleshooting - Pentair MagicBowl Water Effect Installation And User Manual

Set up a
MagicBowl
To setup an AUX circuit to control the MagicBowl Water Effect, assign the circuit light
function an auxiliary relay circuit (AUX 1), then assign the circuit name for that light circuit.
The light circuit name will appear on the main screen. Each MagicBowl Water Effect must
also be assigned a circuit function. To assign a Circuit Name for the MagicBowl Water
Effect, go to: MENU > SETUP > ADVANCED > CIRCUIT FUNCTIONS
Setup a MagicBowl Water Effect function circuit: Assign each light auxiliary relay
circuit a circuit name, then assign that light relay circuit in the "CIRCUIT FUNCTIONS"
section, as "INTELLIBRITE." To setup the MagicBowl Water Effect circuit function (use
the "MagicBowl" circuit name):
1. Press the button next to the AUX button (the relay auxiliary circuit
connected to the MagicBowl light.
2. Press the right or left side (PREV/NEXT) button next to "MagicBowl." Scroll
through the circuit functions until "MagicBowl" is displayed.
3. Press the SAVE button on the bottom of the screen. Press the EXIT button to
return to the main screen.
Assign the MagicBowl Water Effect circuit to the Lights screen:
4. Press the Lights button on the bottom of the screen.
5. Press the right side button next to "CONFIGURE."
6. Press the button next to "NONE" to assign a light circuit to the selected
button. Light names can be setup to display on the left side for "Spa" features
and on the right side for the "Pool" features.
7. Press the top left or right side button to scroll through the available light
circuits which can be used for the MagicBowl lighting features. Select at the
circuit name you wish to use. The displayed circuit names are circuit names
that were previously assigned when assigning a circuit
function.
Operating and Selecting
Special Light Features: Up to twelve (12) light circuits can be displayed on the main
Lights screen (special light features). From the Lights screen you can activate the
MagicBowl by turning it on or off. Assuming each MagicBowl Water Effect and FixFX™
LED Light has its own relay and separate circuit.

Troubleshooting

PROBLEM
The light will not
illuminate.
Light does not function
properly.
Water Effect Circuit Function
MagicBowl Water Effect
Check the ground fault wiring and reset if necessary.
Check the light wiring connection to the junction box at
the pool side and to the main circuit breaker.
Be sure that there is proper AC power applied to the
light.
MAGICBOWL WATER EFFECT Installation and User's Guide
CAUSE/ACTION
17