Pentair MagicBowl Water Effect Installation And User Manual page 11

6. Install the new FireFX™ LED Light assembly: Push the light into the
niche while pulling the power cord from the junction box or transformer.
Note: This task requires two persons: One person to push the FireFX
LED light into the niche, and the other person to pull light's power
cable through the conduit from the junction box or transformer.
7. Push the grommet pre-installed around the cable into the conduit opening
until it is firmly seated in the conduit. See figure 1.
8. Place the light engine into the niche so that it sits firmly on the ribs inside
the niche.
Note: If the light engine is not seated properly in the niche it will be
damaged by the bowl, voiding the warranty.
9. Final check for proper FireFX LED light operation: Switch on the main
switch or circuit breaker to the 12 VAC transformer and the switch that
operates the FireFX LED light itself. The light should illuminate when the 12
VAC power is applied. If not recheck the installation steps.
MAGICBOWL WATER EFFECT Installation and User's Guide
7