Pentair MagicBowl Water Effect Installation And User Manual page 13

INSTALLING THE MAGICBOWL™ WATER EFFECT ON THE NICHE
7. Install the supplied water spout assembly by screwing the threaded end into the
bulkhead assembly inside the bowl.
8. Should you need to remove the bowl remove the water spout assembly from the
bulkhead, unscrew the retaining nut and gasket from the inside of the bowl and
lift the bowl up and over the center fitting. The bulkhead will stay attached to the
niche.
9. To re-install the bowl, place the thick foam gasket on the bulkhead, lower the bowl
over the spout and bulkhead fitting, install the gasket and nut and torque until
tight (10ft.-lbs). Install the water spout assembly.
MAGICBOWL WATER EFFECT Installation and User's Guide
9