Table of Contents
Advertisement
REPLACING THE FIREFX™ LED LIGHT ASSEMBLY
(AFTER ELECTRICAL REQUIREMENTS ARE MET)
The following removal and installation instructions describe how to remove and install the
FireFX™ LED Light assembly. Also use these instructions after completing the following
light replacement procedure.
hazard which could result in death or serious injury to pool users, installers, or
others due to electrical shock, and may also cause damage to property.
1.
Switch off electrical switch or circuit breaker at the source.
2.
Remove Junction Box or Transformer cover. Disconnect the light wires and attach a
fish tape to the existing light power cord. This will assist in pulling the replacement
light power cord through the conduit back to the junction box.
3.
Remove any standing water in the bowl. Remove the water spout assembly from
the bulkhead, unscrew the retaining nut and gasket from the inside of the bowl and
lift the bowl up and over the center fitting.
4.
Slowly pull the light and attached power cord (with attached fish tape) out of the
niche. Pull the light's power cord and fish tape out of the niche and place the light
on the deck.
5.
Attach the new light power cord to the fish tape and carefully feed the fish tape and
cable to the junction box.
6.
At the 12 VAC transformer or junction box, cut off any extra cord. Leave at least six
(6) inches (15.2 cm) of cord in the Junction Box or transformer to facilitate the light
installation, niche inspection. Cut off any extra cord.
7.
Strip back three (3) inches of the outer cord jacket to expose the two insulated
wires (be careful not to damage the insulation on the two (2) inner wires). Strip
back the two conductors. Be careful not to damage the copper conductor.
8.
Connect both (2) wires to the corresponding circuit wires in the Junction Box or 12
Volt AC Transformer (black wire to power, white wire to common) and secure the
Junction Box cover in place.
9.
Push the grommet pre-installed around the cable into the conduit opening until it is
firmly seated in the conduit.
10. Place the FireFX LED light assembly into the niche so that it sits firmly on the ribs
inside the niche.
Note: If the FireFX LED light assembly is not seated properly in the niche it
will be damaged by the bowl, voiding the warranty.
11. Switch on the main switch or circuit breaker to the 12 VAC transformer and the
switch that operates the FireFX LED light itself. The light should illuminate when
the 12 VAC power is applied. If not recheck the installation steps.
12. To re-install the bowl, place the thick foam gasket on the bulkhead, lower the bowl
over the spout and bulkhead fitting, install the gasket and nut and torque until tight
(10ft.-lbs). Install the water spout assembly.
Failure to bring the pool or spa's electrical system up to code
requirements before installing the light will create an electrical
MAGICBOWL WATER EFFECT Installation and User's Guide
11
Hide quick links:
Advertisement
Table of Contents
