Installing The Magicbowl Water Effect Assembly On The Niche - Pentair MagicBowl Water Effect Installation And User Manual

8
INSTALLING THE MAGICBOWL™ WATER EFFECT ON THE NICHE
1. Only install bowl after your finish work is complete to avoid causing any damage
to the bowl.
2. Only install bowl after your finish tile and or cap stone is installed as bowl will sit
upon this surface once installed.
3. Test and confirm the FireFX™ LED Light head is working prior to installing the
bowl.
4. Bowl comes shipped with bulkhead fitting spout installed.
Note: Do not remove the bulkhead assembly from the bowl. The bulkhead
assembly MUST be installed on the bowl while gluing onto the niche.
5. When ready to install the bowl you should apply commercially available PVC
cement to the inside of the slip portion of the bulkhead fitting and the center
niche pipe.
Notice: Be sure not to get glue on the FireFX LED Light assembly
when installing the bowl on the niche flange.
6. Lower the bowl with attached fitting onto the center niche pipe, pushing down
firmly until the bowl is supported by the flange of the niche and mounting
surface.
MAGICBOWL Water Effect Installation and User's Guide
Apply glue
Niche flange
(the bowl should be
resting on)
Bulkhead