Table of Contents
Advertisement
7. Help
Display
No display
• Try recharging or replacing the battery pack.
• Reset the units. Disconnect the battery pack of the parent unit and
unplug both the units' electrical power, then plug them back in.
• Is the unit turned on?
Press and release
• Is the correct camera channel number selected?
Change the camera channel number, if necessary.
Registration
If the Camera unit has lost its link with the parent unit
• Try recharging or replacing the battery pack.
• If the Camera unit is too far away it may be going out of range, so
move the Camera unit closer to the parent unit.
• Reset both units by unplugging their batteries and mains electrical
power. Wait for 15 seconds before reconnecting them. Allow up to
one minute for the Camera unit and the parent unit to synchronise.
• See section "2.4 Registration" if there is a need to re-register the units.
Interference
Noise interference on your parent unit
• Your camera and parent units may be too close. Move them further
away from each other.
• Make sure there is at least 1 metre between the 2 units to avoid
audio feedback.
• If the Camera unit is too far away it may be going out of range, so
move the Camera unit closer to the parent unit.
• Make sure the camera and parent units are not near other electrical
equipment, such as a television, computer or cordless/mobile telephone.
18
F
on the parent unit to turn it on.
Help
Advertisement
Table of Contents
