Table of Contents
Advertisement
2.2
Parent unit battery installation
Red
1.
Turn the belt clip so that it is in the hanging position.
2.
Loosen the screw in a counterclockwise direction using a small
screwdriver. Remove the battery cover.
3.
Insert the wire tab of the rechargeable battery pack into the
contact slot as shown above and fit the battery pack into the
compartment.
4.
Close the battery compartment and tighten the screw in a
clockwise direction.
F
5.
Press
screen will illuminate and the unit will be ready.
6.
Press and hold
The battery icon
to be recharged. The battery pack takes about 16 hours to charge fully.
NOTE
When the main power is connected, the charge icon
and the battery icon
Getting started
Black
to turn ON the parent unit. In a few seconds the LCD
F
to turn OFF the parent unit.
indicates that the battery pack is low and needs
also displays while the battery is charging.
screw
is displayed
9
Advertisement
Table of Contents
