Dimm Installation; Dimm Removal - Supermicro C7C232-CB-ML User Manual

DIMM Installation

1. Insert DIMM modules in the following
order: DIMMB2, DIMMA2, then DIMMB1,
DIMMA1. For the system to work properly,
please use memory modules of the same
type and speed on the motherboard.
2. Push the release tabs outwards on both
ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the
receptive point on the memory slot.
4. Align the notches on both ends of the
module against the receptive points on the
ends of the slot.
5. Use two thumbs together to press the
notches on both ends of the module
straight down into the slot until the module
snaps into place.
6. Press the release tabs to the lock positions
to secure the DIMM module into the slot.

DIMM Removal

Reverse the steps above to remove the DIMM
modules from the motherboard.
AUDIO
OBR1
HS1
BUZ1
PCH
NGFFB1
GPIO1
I-SATA5
I-SATA4
I-SATA3
I-SATA1 I-SATA0
Release Tabs
Press both notches
straight down into
the memory slot.
31
Chapter 2: Installation
KB/MOUSE
USB4/5/6/7
USB0/1
(3.0)
LAN1
FANS1
FANS2
C7C232-CB-ML
Rev. 1.00
CN2
FANC1
CPU
BT1
DIMMA1
DIMMA2
DIMMB1
DIMMB2
CN1
DBGH1 TPMH1
PCHDR1
Notches