GE GLDT690J__BB Technical Service Manual page 27

Sump Assembly
prevents small particles from reaching the sump.
nut holds the sump gasket and sump to the bottom
and sump clamping nut are accessed from inside
the dishwasher. The gasket and sump are located
under the tub in front of the motor pump assembly.
Sump Assembly Removal
1. Disconnect power.
2. Open the dishwasher door and remove the
bottom rack.
3.
counterclockwise to remove.
4.
Cylindrical
Filter
Steel Filter
5.
Micro Filter
The sump clamping nut turns
It may be helpful to insert a 3/4 in. wide x 4 1/2 in.
long piece of wood between the clamping nut tabs
break the factory seal.
6. Remove the sump clamping nut.
7. Remove the sump gasket (not shown) and sump.
Clamping
Nut
8. Remove the dishwasher from its installation.
9. Lay the dishwasher on its back.
10. Disconnect the thermistor wire harness.
11. Remove the pressure switch hose from the
sump.
Sump
– 27 –
Tabs
Tabs
Sump
Wire Harness
Pressure Switch Hose