Table of Contents
Advertisement
Water Inlet Valve
The water inlet valve is electronically controlled and
liters per minute) with incoming water pressure
of 20 to 120 PSI. The water valve is mounted on a
bracket located on the left side of the front brace.
The water valve has an approximate resistance
value of 1k ohms and is energized for approximately
Operation of the water valve can be checked by
using the service mode. (See Service Mode.)
Water Valve Removal
1. Disconnect power.
2. Remove the outer door panel (see Outer Door
Panel Removal).
3. Remove the 2 Phillips head screws, washers,
and the access panel.
4.
valve inlet.
5. Remove the 2 Phillips head screws that hold the
bracket to the front brace.
6. Disconnect the 2 wires from the solenoid.
Bracket
Inlet
Disconnect
The clamp is easily damaged during
removal and should not be reused. Use the screw-
type hose clamp provided with the new valve.
7. Remove the clamp and the outlet hose from the
valve.
Outlet Hose
Clamp
8. Remove the four 1/4 in. hex head screws and
Ensure the O-ring is retained in the valve
upon reassembly.
O-Ring
Page 22
Hide quick links:
Advertisement
Table of Contents
