7. Locate the wires leading to the heating element
terminals and pull down the 2 nylon terminal
covers.
8. Disconnect the 2 wires from the heating
element.
Nylon Terminal Covers
Heater Wire
9. Remove the outer 8 mm nut that attaches the
ground wire to the element mounting bolt.
Outer Nut
Ground Wire
10. Remove the inner 8 mm nut, washer, and spacer
Heater Wire
11. Lift the right side of the element and release it
– 20 –
that attaches the element to the bottom of the
tub.
Washer
from the 2 retainers.
Spacer
Inner Nut