GE GLDT690J__BB Technical Service Manual page 17

Detergent/Rinse Module
The control panel must be removed to access
the detergent/rinse module (see Control Panel
Removal).
The detergent/rinse module is connected by 2 wires
and held in place by 6 Phillips head screws and 2
brackets.
The detergent/rinse module operates on 120 VAC
and has an approximate resistance value of 2k
ohms
Bracket
The detergent/rinse module automatically
dispenses both the detergent and the rinse agent at
the appropriate times. The module is activated twice
during a wash cycle. Detergent is dispensed at the
beginning of the main wash cycle and rinse agent at
Operation of the detergent/rinse module can be
checked by using the service mode (see Service
Mode).
slides up the right-hand path of the connecting rod
(1). This action releases the detergent cover.
Bracket
Disconnect
Disconnect
the lever
When deactivated, the lever returns down the left-
hand path and comes to rest under the notch (2) in
the center of the connecting rod.
At the second activation, the lever lifts the
connecting rod by the notch. This action lifts the
rinse dispenser plunger (3) and releases the rinse
agent. When deactivated, the lever returns to its
original starting position.
Make sure the rubber seal is retained in the
recessed groove before reinstalling the module to
the door assembly.
– 17 –
1
2
3
Seal