Configuration Procedure - H3C S10500 Series Configuration Manual

Hide thumbs Also See for S10500 Series:

Table of Contents

Figure 3 Network diagram

Configuration procedure

This section only contains EVB configurations.

Configuring the EVB bridge

# Create VLAN 100 on EVB bridge 1.

<EVB_bridge1> system-view

[EVB_bridge1] vlan 100

[EVB_bridge1-vlan100] quit

# Enable EVB on GigabitEthernet 1/0/1 that connects to EVB station 1, and configure

GigabitEthernet 1/0/1 to operate in trunk mode.

[EVB_bridge1] interface gigabitethernet 1/0/1

[EVB_bridge1-GigabitEthernet1/0/1] evb enable

[EVB_bridge1-GigabitEthernet1/0/1] port link-type trunk

[EVB_bridge1-GigabitEthernet1/0/1] quit

# Enable LLDP on EVB bridge 1 globally. Enable LLDP on GigabitEthernet 1/0/1, and configure the

Nearest non-TPMR Bridge agent for LLDP to operate in TxRx mode.

[EVB_bridge1] lldp global enable

[EVB_bridge1] interface gigabitethernet 1/0/1

[EVB_bridge1-GigabitEthernet1/0/1] lldp enable

[EVB_bridge1-GigabitEthernet1/0/1] lldp agent nearest-nontpmr admin-status txrx

[EVB_bridge1-GigabitEthernet1/0/1] quit

# Specify the IP address and port number for the default VSI manager on EVB bridge 1.

[EVB_bridge1] evb default-manager ip 192.168.1.1 port 8080

Configure other EVB bridges in the same way. (Details not shown.)

Table of Contents