Activating A Vsi Interface Or Vsi Aggregate Interface - H3C S10500 Series Configuration Manual

The Layer 2 aggregate interface where the S-channel that is associated with the S-channel
aggregate interface is created.
•
Do not create a VSI filter that contains the same VLAN on the same VSI aggregate interface or
on other VSI aggregate interfaces that belong to the same S-channel aggregate interface. If you
do so, the system displays an error message.
•
Activate a VSI aggregate interface after configuring a VSI filter, and deactivate a VSI aggregate
interface before removing a VSI filter.
To configure a VSI filter:
Step
1. Enter system view.
2. Enter VSI interface view or
VSI aggregate interface
view.
3. Configure a VSI filter.

Activating a VSI interface or VSI aggregate interface

Traffic policy configuration on a VSI interface or VSI aggregate interface takes effect only when the
VSI interface or VSI aggregate interface is activated. When a VSI interface or VSI aggregate
interface is not activated, do not configure any settings other than filters on either interface. For more
information about traffic policing, see ACL and QoS Configuration Guide.
Activate a VSI interface or VSI aggregate interface after configuring a VSI filter, and deactivate a VSI
interface or VSI aggregate interface before removing a VSI filter.
To activate a VSI interface or VSI aggregate interface:
Step
1. Enter system view.
2. Enter VSI interface view or
VSI aggregate interface
view.
3. (Optional.) Set the expected
bandwidth of the VSI
interface or VSI aggregate
interface.
4. (Optional.) Restore the
default settings for the VSI
interface or VSI aggregate
interface.
5. (Optional.) Set a description
for the VSI interface or VSI
aggregate interface.
6. Activate the VSI interface or
VSI aggregate interface.
Command
system-view
interface { s-channel |
schannel-aggregation }
interface-number:channel-id.vsi-l
ocal-id
evb vsi filter [ group group-id ]
vlan vlan-id [ mac mac-address ]
Command
system-view
interface { s-channel |
schannel-aggregation }
interface-number:channel-id.vsi-l
ocal-id
bandwidth bandwidth-value
default
description text
evb vsi active
11
Remarks
N/A
N/A
By default, no VSI filters exist.
Remarks
N/A
N/A
By default, the expected
bandwidth of a VSI interface or
VSI aggregate interface is the
default maximum bandwidth of
the physical port to which the
interface belongs.
N/A
The default description
information is "interface name
Interface."
By default, no VSI interface or VSI
aggregate interface is activated.