Specifying Whether The Link Connected To A Port Is A Point-To-Point Link; Enabling Mstp; Performing Mcheck Operation; Configuration Prerequisites - H3C S3100-52P Operation Manual

Hide thumbs Also See for S3100-52P:
Table of Contents

Advertisement

Operation Manual – MSTP
H3C S3100-52P Ethernet Switch
<Sysname> system-view
[Sysname] stp interface Ethernet 1/0/1 instance 1 port priority 16
2)
Perform this configuration in Ethernet port view
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] stp instance 1 port priority 16
1.4.9 Specifying Whether the Link Connected to a Port Is a Point-to-point
Link
Refer to

1.4.10 Enabling MSTP

Refer to

1.5 Performing mCheck Operation

Ports on an MSTP-enabled switch can operate in three modes: STP-compatible,
RSTP-compatible, and MSTP.
A port on an MSTP-enabled switch operating as an upstream switch transits to the
STP-compatible mode when it has an STP-enabled switch connected to it. When the
STP-enabled downstream switch is then replaced by an MSTP-enabled switch, the
port cannot automatically transit to the MSTP mode. It remains in the STP-compatible
mode. In this case, you can force the port to transit to the MSTP mode by performing
the mCheck operation on the port.
Similarly, a port on an RSTP-enabled switch operating as an upstream switch turns to
the STP-compatible mode when it has an STP-enabled switch connected to it. When
the STP enabled downstream switch is then replaced by an MSTP-enabled switch, the
port cannot automatically transit to the MSTP-compatible mode. It remains in the
STP-compatible mode. In this case, you can force the port to transit to the
MSTP-compatible mode by performing the mCheck operation on the port.

1.5.1 Configuration Prerequisites

MSTP runs normally on the switch.

1.5.2 Configuration Procedure

You can perform the mCheck operation in the following two ways.
I. Perform the mCheck operation in system view
Follow these steps to perform the mCheck operation in system view:
Specifying Whether the Link Connected to a Port Is Point-to-point
Enabling
MSTP.
1-41
Chapter 1 MSTP Configuration
Link.

Advertisement

Table of Contents
loading

Table of Contents