Table of Contents
Advertisement
D Auto power save function "PS"
The auto power save function reduces current drain by deac-
tivating the receiver circuit for preset intervals.
• ON : The power save function is turned ON. The power save func-
tion will activate when no signal is received, and no operation
is performed for 5 sec.
• OFF: The power save function is turned OFF.
Push
Power save ON
(default)
Power save OFF
D Self check function "SC"
The self check function checks the transceiver conditions by
itself, and informs you in case a problem is found. Self check
automatically and quickly runs through its diagnostic steps
each time the radio is turned ON. Afterwards, the radio
switches to normal operation mode.
• Temperature : Outside of –35°C to +80°C; –31°F to +173°F
(approx.)
• Connected battery voltage
Push
Self check OFF (default)
When error messages as shown below are displayed, see
troubleshooting for advice. (p. 28)
Temperature error
5
SET MODE
Self check ON
Battery voltage error
5
13
Advertisement
Table of Contents
