Introduction; Replacement Parts - B&C Technologies FM7 Computer Programming And Operating Instructions

FM7 Computer
The FM7 Computer is a powerful and
programable solid state controller. Up to 30
programs, each with up to 15 cycles can be
programmed. In addition, the FM7 can display
5 languages - English, Italian, German, Spanish
and French. The water level can be
programmed, and is accurate to 1 cm (0.4 in).
Spin speeds are fully programmable in RPM.
In the event of power failure, the operator is
prompted to continue the cycle, or abort it.
Keypad
Number key, Insert Key. Enables a new
INS
1
cycle to be inserted in an existing program
during programming. During operation,
press and hold for cylinder RPM.
DEC Number key, Decrement Key. Lowers the
2
current value during programming mode.
Number key, Increment Key. Raises the
INC
3
current value during programming mode.
If pressed simultaneously with the TEMP or
LEVEL key, allows temporary
modification.
Number key, Temperature Key. Allows
TEMP
4
temporary modification of the target
temperature if used with the INC and DEC
keys. Displays current temperature in wash
cylinder.
Number key, Level Key. Allows temporary
LEVEL
5
modification of the target water level if
used with the INC and DEC keys. Displays
current water level in wash cylinder.
Number key, Time Key. Displays the
TIME
6
watch dog timer value for the current step.

Introduction

PAUSE
ENTER
RESET
The Advance key is now a hidden key, located
between the Stop and Start buttons. Pressing this
hidden key advances to the next program step.
During final spin, the remainder of the spin is
aborted. If pressed before starting a program, it
allows the operator to begin the program at any
segment. During programing, skips to the next
segment.
3
7
8
Number keys
9
Number key, Pause Key. If pressed during
0
operation, pauses the wash program
indefinitely. Not active during distribution
or spin.
Confirms settings in creation and editing of
wash programs. During operation, shows
the current segment or program number.
Deletes any selection or setting.
DEL
Terminates the current activity (operation
or programming). While the machine is
powered but not executing a program, can
be pressed with RESET to see the current
firmware version.
Starts execution of the currently selected
wash program. Restarts a paused
program. When pressed with RESET,
function codes can be entered to program
and setup the machine. See the quick
reference list on the next page.