Cycle Programming - B&C Technologies FM7 Computer Programming And Operating Instructions

Cycle libraries can be created for later use in
the Wash programming step. When the
machine is stopped, press the START and
RESET buttons together. The display is:
n?
Using the keypad, type 12 and press ENTER.
For two seconds, the display shows:
EDIT CYCLES>
The message for choosing the programming
cycle is then displayed:
PREWASH = ?
Pressing INC or DEC will show the other cycle
types in succession:
WASH = ?
SPIN = ?
RINSE = ?
UNROLL = ?
When the cycle type you wish to edit is
displayed, press ENTER to begin creating or
editing of the cycle. As an example, we will go
through programming a Prewash cycle.
PREWASH = ?
Using the numerical keypad, enter the cycle
you wish to create or modify. After you have
entered the number and pressed ENTER, there
are two possible cases:
The cycle chosen does not exist and has
>
to be programmed. (This Page)
The cycle chosen does exist. If this is
>
the case, you can view and modify the
cycle as needed. (See page 17, and
charts beginning on page 11).
Programming

Cycle Programming

14
New Cycle Creation
If the cycle you chose does not exist, you will
be taken directly into the programming mode.
For two seconds, the display will show:
START STEP 1
The display then changes to:
COOL DOWN? --
You can now define for step 1 whether the cool
down feature is activated. If you wish to
activate cooldown, press ENTER, and the
display changes to:
COOL DOWN? ON
To implement the cooldown phase, five
additional parameters must be entered. These
are discussed in the next section. If you do not
wish to activate the cooldown phase, press INC.
The display will show:
FILL TO TEMP? --
You can now define for step 1 whether Fill to
Temperature is enabled. A target temperature
can be programmed and the machine will use a
combination of the hot water fill valve and the
cold water fill valve to maintain a given
temperature. If you wish to activate
temperature controlled fill, press ENTER. The
display will change to:
FILL TO TEMP? ON
To implement temperature controlled fill, four
additional parameters must be entered. These
are discussed in the next section. If you do not
wish to activate temperature controlled fill,
press INC. The display will show:
DRAIN? --