B&C Technologies FM7 Computer Programming And Operating Instructions page 13

Cycle Programming Sequence
To turn on a function, press Enter, to turn off a function press Reset. Press Enter to edit a numerical
value (RPM, Time, etc.). Note: Setting a function to zero DOES NOT disable that function.
ON to turn on chemical signal 5, and
Chem 5 flush cup 5 in the supply dispenser, if
equipped. -- means the supply is off.
INC
3
Aux 1
Auxiliary 1 output
INC
3
ON turns on Auxiliary Fill.
Aux Fill
-- means the valve is off.
INC
3
Aux 2 Auxiliary 2 output
INC
3
ON turns on drive balance relay - only
Spin Test
used in extract cycles. -- means the relay
is off.
INC
3
ON enables the machine to rotate, in
concert with RPM, below. -- means
Agitation
no cylinder rotation. More information
on page 8.
INC
3
Set the RPM - see chart on page 29 for
RPM details on recommended speeds for a
particular machine.
INC
3
Chem 6 ON to turn on chemical signal 6.
-- means the supply is off.
INC
3
Chem 7 ON to turn on chemical signal 7.
-- means the supply is off.
INC
3
ON to turn on chemical signal 8.
Chem 8
-- means the supply is off.
INC
3
continued
12