B&C Technologies FM7 Computer Programming And Operating Instructions page 10

Notes on Agitation Programming
There are a number of different modes
available for motor programming:
1. Forwards - Pause - Backwards
FWD T = XXs
PAUSE T = XXs
REV T = XXs
2. Forwards - Pause
FWD T = XXs
PAUSE T = XXs
REV T = S0
3. Forwards
FWD T = XXs
PAUSE T = S0
4. Pause - Backwards
FWD T = S0
PAUSE T = XXs
REV T = XXs
5. Backwards
FWD T = S0
PAUSE T = S0
REV T = XXs
Programming
Agitation Programming continued
9
The minimum pause time that can be
programmed between forward and backwards
is 2 seconds. The maximum time is 239
seconds.
Cylinder speed is programmed during cycle
programming. In this mode, each step can be
programmed with different values if desired.
B&C Stock Agitation Assignments
Agitation Forward
1 16
2 4
3 5
14 0
15 1
Agitation 1 - used for normal wash agitation.
Agitation2 - used for gentle wash agitation.
Agitation3 - used for soak formulas
Agitation14 - Used for Unroll cycles (reverse
only)
Agitation15 - Used for Spin cycles (forward
only)
Pause Reverse
4 16
16 4
115 5
0 1
0 0