Service Functions - B&C Technologies FM7 Computer Programming And Operating Instructions

All machine functions are accessed by pressing
START and RESET simultaneously. At the
changed prompt, key the required function,
then press ENTER.
12 Cycle (segment) Programming
27 Wash Programming
45 Agitation programming
144 Enables the FM7 communication mode
so that programs can be downloaded and
uploaded to the control.
181 Clears all programs. Will delete
anything programmed in memory.
201 Language: 1 - Italian, 2 - English, 3 -
German, 4 - Spanish, 5 - French.
205 16 or 24 relay output board (B&C
equipment uses the 24 relay version).
207 Maximum RPM - DO NOT MODIFY!
209 Temperature hysterisis (1 - 10 degrees
C). 3 degrees C is default.
210 Temperature displayed in degrees C
211 Temperature displayed in degrees F
212 Maximum water level (10 - 100cm)
213 Minimum water level for heating (2 -
30cm)
214 Display number of hours in operation
215 Display total number of programs run
216 Display number of wash programs run
since last maintenance request.
217 Reset Service Alarm
218 Display and set the number of washes
between service alarms.
219 Coast down safety timer. DO NOT
MODIFY!
220 Deletes all programs and cycles from
memory.
221 Copy from control to the memory card
222 Copy from memory card to the control
(programs and cycles only)
223 Copy from memory card to the control
(programs, cycles and parameters)
225 Disables the ADVANCE key
230 Maximum water level allowed during
spin DO NOT MODIFY!

Service Functions

Access Functions
Service Alarm
After 450 wash programs have completed, the
machine will call for maintenance:
SERVICE ALARM!
The message appears at the start of a program,
and is repeated at the beginning of each wash
program until reset (see function 217, pg 26).
Disable the Machine
Function 118
Upon entering this function, the machine will
not operate. The power must be cycled (turned
off, then back on) for the function to activate.
Upon power up, the display will show:
!
To re-enable the machine, press, then release
the Emergency Stop Button, then type 118.
START + RESET is not needed.
Change Language
Function 201
The control can display in 5 different
languages. To change the language, use
function 201. Upon entering the function, the
display changes to:
LANGUAGE
Type the number which corresponds to your
language, followed by ENTER:
1 - Italian
2 - English
3 - German
4 - Spanish
5 - French
16 or 24 Relays
Function 205
Each time function 205 is entered, the
controller toggles between 16 and 24 relay
setup. After entering 205, the display shows
the current mode. B&C uses 24 relays.
25