Metric Conversion Chart - B&C Technologies FM7 Computer Programming And Operating Instructions

Service Alarm
Function 218
This function sets the number of washes before
the service alarm is activated. The default
value is 450. This means that after 450 wash
programs have been completed, the service
alarm will be displayed. To change the value,
use the INC or DEC keys. The value changes
by 10 each time a key is pressed. You may
hold down the key to change the number
quickly. Once the desired value is reached,
press the ENTER key to confirm.
Spin Safety Coast Down Time
Function 219
Upon entering function 219, you display the
spin safety coast down time. If you wish to
change this (not recommended), press ENTER,
followed by the new value, then ENTER to
confirm. To exit without changing the value,
press RESET.
DO NOT MODIFY
WITHOUT CONSULTING
B&C TECHNOLOGIES!
EXTREME MACHINE
DAMAGE AND PERSONAL
INJURY CAN OCCUR!
Memory Erasure
Function 181
Function 220
Partial or total clearing of the control memory is
possible. Function 220 clears all programs and
cycles, but machine parameters are not erased.
Function 181 erases all programs and cycles,
and also erases all machine parameters, thus
reinitializing the control. After keying in the
function, the display reads: "DELETE
E2PROM?" Press ENTER to confirm. Press
RESET to abort the procedure.
Service Functions
Access Functions continued
Disabling the Advance Key
Function 225
This function disables the ADVAN key. This
function toggles between enabled (ON) and
disabled (--). Default value is enabled (ON).
Maximum Level in Spin
Function 230
This function sets the
maximum water level during
execution of a spin. If you do
not wish to modify the value,
press RESET. If you want to
modify the value, press
ENTER, followed by the new
value, then ENTER again to confirm. Allowed
values are from 2 to 60 cm.
DO NOT MODIFY WITHOUT CONSULTING
B&C TECHNOLOGIES OR A QUALIFIED
SERVICE TECHNICIAN! EXTREME
MACHINE DAMAGE CAN OCCUR!
Software Version
STOP + RESET
Pressing the STOP and RESET keys
simultaneously displays the installed firmware
version.
Cylinder Speed
INS
Pressing the INS key during execution of a
wash program displays the commanded wash
cylinder speed in RPM.
27